• DISPERSION CONTACT ADHESIVE

• VERY LOW VOC-EMISSION

• EMICODE EC 1 PLUS

• POWERFUL ENOUGH TO BEAR HIGH TENSIONS          

• HIGH INITIAL ADHESION STRENGTH

• REACTIVATED THROUGH WARMTH

• TOOL INCLUDED

 

APPLICATION

For one-sided bonding of: Woolfelt on walls and ceilings

 

HOW TO TREAT FELT

The rolls must be unpacked and left to acclimatize in the conditions as specified.

The maximum allowed percentage of residual moisture of the substrate is 4.5%.

 

FINISHING OF THE SEAM

Cut felt twice up to 2 mm thickness. Place joint-to-joint over 2 mm thickness.

 

PRIMING

The surface must be clean, permanently dry, and free of grease, dirt and dust. Highly porous substrates, e.g. new stucco and new drywall, must be primed with a primer to be applied with a fleece roller or by means of spraying

 

PROCESSING CONDITIONS

The required processing conditions 24 hours before, during and 24 after gluing are

Required surrounding temperature 18 - 23 oc
Temperature for material and subfloor 15 - 23 oc
Relative humidity 40 - 80%

 

PROCESSING ADVICE

The substrate must be coated with Felt Glue with the enclosed structure roller. The felt must be applied directly to the wet glue. The glue may not become opaque or dry before the felt is laid. Woolfelt can be positioned. After placement it is advisable to roll the woolfelt with a solid rubber roller.

 

Frost

Frost free transportation and storage.

 

GENERAL

Fresh glue stains must be removed with water immediately.

Tools must be cleaned with water immediately.

 

Wall Hollandfelt
Wall Hollandfelt
Wall Stedelijk Amsterdam
Wall Stedelijk Amsterdam